Agglomerators
The agglomerator is an equipment intended to increase the density of plastic films, resulting in agglomerated material for direct feed to the processing machines (injection machines, extruders and blow moulders).
The agglomeration is carried out by a mechanical process, and there is no heat source, therefore there is no degradation of the raw material.
Typical applications: agglomeration of raw material bags, lateral cuts of coils, loose films, etc.
Descarregar catálogo
Products 
Suggested
Shredders for pipes and profiles
This range of shredders is used for recycling of pipes and thick, large-section profiles. The materials to be recycled are fed in via a loading tunnel with a safety cover. The profiles are hydraulically pressed against the rotor, and the movement of the ram is controlled by the motor’s consumption. The design of the blades, rotor and infeed system, have been optimized to obtain a high-density end product, thanks to the large thickness of shredded material that is obtained.
Double shaft shredders
The double shaft shredder allows the processing of a wide variety of materials, dimensions and densities, being suitable for the reduction of bulky products. It is equipped with a large hopper and two shafts, which support the cutting discs, being driven by two independent gear motors. The cutting discs are manufactured in high quality steel and wear resistant. The reduced speed of rotation allows low energy consumption and noise level. The inversion system allows to, in case of excessive load, is automatically activated the temporary inversion of the rotors movement in order to avoid the overloading. As an option, an upper ram can be mounted for processing of bulky parts (bumpers, containers, etc.). The main applications are: - plastic materials - rubber / tires - paper / cardboard - wood - cables
Granulators XRP
This range of granulators is designed specifically to size reduce extruded profiles up to 6 meter long. The horizontal opening allows ergonomic feeding and profiles are automatically by the rotor. Short length profiles can be fed manually or with belt conveyor to a top mounted hopper. Its compact design, including the soundproofed version, enables the equipment to be installed in the production area.
Screw dryer-pressers
The screw dryer-presser removes part of the water from the material after washing, allowing very efficient drying without loss of raw material. The screw conveys and compresses the material by removing water through perforated screens. At the end, a decompressor is mounted to deliver the loose material to the next process. It stands out for its efficiency and low noise.